Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Motion Control and Motor Drives. Message 1 of 4. How to connect the 73xx inhibit and command signal outputs to third party dr Who is an NI Drive Partner? With NI SoftMotion, you can use a LabVIEW project to configure all of your motion axis settings, test your configuration, tune your motors, and quickly integrate custom motion control into your application.
|Date Added:||16 January 2015|
|File Size:||69.77 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I was able to find some other information on this drive in other laabview forum posts. Or does the mode status register have to be changed? Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Message 4 of 4.
Despite most EtherCAT-capable drives conforming to the CiA standard, many operational behaviors differ between drive vendor implementations of CiA If you only need a handfull of commands, then this is probably the most straighforward for you to get going.
Most Active Hardware Boards: As a start, could you post the XML file in question so that I could look through it? With NI SoftMotion, you can use a LabVIEW project to configure all of your motion axis settings, test your configuration, tune your motors, and quickly integrate custom motion control into your application.
I’m not familiar with this drive, but am familiar with ethercat. Most Active Hardware Boards: Who is an NI Drive Partner? Thank you for replying.
Some other command may actually ask for the instrument to write back some data. Motion Control and Motor Drives.
Softmotion module with Elmo Drive (Slave) – Discussion Forums – National Instruments
I have labivew controlling experience and have no assistance other than the tutorials and textbooks so I appreciate the help. For a more comprehensive list, see this product support page. You can make sub VIs that implement each function that you need.
Message 3 of 4.
Since the functions provided by NI SoftMotion are hardware-agnostic, the same LabVIEW control code can be re-used with a variety of different hardware with little to no change to the code.
I uploaded the xml file required to detect this third party slave device, and it was a success. LabVIEW snapshot is also attached. Back to Top 4. You could use the serial example to write your entire program.
Have a great day. Let me know if this helps. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as elo type.
Motion Control and Motor Drives
So, I added the new slave device to the project. In this case, you need to have a VISA Read after the write to be able to read the data into your computer. If I don’t write an Instrument Drive will I have limited capabilities?
Integrators can use the SoftMotion Drive Interface as a method for developing code albview can work with any hardware for which a SDI Plug-in is available. Message 4 of 4. Then take a look at what commands this will require.